Aquarium Systems Sea Test - System Control Full Range Tester

The Seatest System Control is designed to be used in conjunction with Seatest's full range of test kits!

This easy to use tester allows you to analyse the results accurately in place of the usual hard to read colourimetric test charts. As a bonus you can also store the results of upto aquariums.

These results can then be uploaded to a computer so you can generate graphic parameter reports; the reports themselves are stored for reference enabling you to build up a picture of the water quality and content over time.

A brilliant piece of kit which won product best in show at the recent Aqua exhibition.

Not convinced? See the review written by Reef builders here!

Guide to test:

4 EASY STEPS TO MAKE A MEASUREMENT
Step 1: Use colorimetric test as usual
Use desired reagent as described in reagent’s instructions. 
Follow all steps and respect all times as if the reading was done 
without colorimeter.
Step 2: Set tank number on device
Step 3: Set reagent type
Step 4: Take reading
Introduce device inside the test tube until it touches the bottom 
part of test tube. Keep device vertical inside the test tube.
Press TEST key and the liquid will be immediately analyzed. 
The concentration of the desired parameter will be shown in the 
device’s screen. No need to make any further operation!

1. CLEAN AFTER USE
After measurement is done it is recommended to clean the 
device. This will avoid contamination from sample to sample 
when making several measures.
To clean the device insert it inside a test tube filled with 10ml of 
water for three seconds. The best is to use same water from the 
tank to clean device.
After device has been cleaned the external part of device can be 
dried using a paper towel.

Once tests have been completed, upload via USB to view water quality graphs and comparisons.